Electronics
Two sets, one bus. The basic set is a charge controller with its RDC-DD: a Mode 3 charger that runs on its own at 16 or 32 A. The smart set adds load balancing: wired over RS485 to a P1 or clamp load balancer, or wireless with the Matter over Thread set; those are finished units, listed under products. Every board is CE, from stock, with an open and documented protocol.
EVSE-C-3x32AEdge EV Charger controller€ 125 excl. VAT (€ 151.25 incl. VAT)AC charge controller board for one Mode 3 charge point, up to 3×32 A (22 kW), with integrated relay drive, per-phase current and voltage metering, and Modbus RTU control. The board inside most EdgeTech-based chargers since 2021.
EVSE-X-DCDRDC-DD (DC residual-current detector)ShippedThe 6 mA RDC-DD (residual direct current detecting device) A separate product, and standard with every EdgeTech charger, charge controller and DIY kit. It lets a Type A RCD be used upstream instead of a Type B (IEC 62955).
EVSE-X-CLCable lock driverShippedDrives the lock of a Type 2 charge socket from the charge controller's lock command, with position feedback. Reserve capacitors keep enough energy on board to release the lock after a power failure, so a car is never held on a dead charger.
EVSE-X-NFCNFC card reader (Modbus)ShippedAn optional card reader that mounts inside the charger box, with its antenna side against the lid, so cards are read through the lid. It reads ISO/IEC 14443 cards and connects to the Modbus line with four wires. Use it with any card as a local lock and unlock, or with a Dutch laadpas over OCPP.
PLC-15118ISO 15118 communication moduleImplemented, on orderAn add-on for the smart charger: HomePlug GreenPHY on the control pilot for ISO 15118 digital communication with the vehicle. With 15118-20 vehicles it shows the state of charge while charging on AC and identifies the vehicle for authorisation. Price on request; V2G under investigation.
Load balancing
The P1 and clamp load balancers, the Matter over Thread set and GridShield are finished units, listed under products. They work the same with chargers you build on our charge controller.
Ordering
Prices are per unit excl. VAT and shipping. Dealers and installers from 5 units; wholesale volume pricing at 10, 50 and 100+ units on request. Custom firmware defaults (address, LED, lock, phases) preloaded on request. How to buy.