My charger does not charge
Charger not charging or not working, offline or showing a fault? Enter the 10-character code from the QR label on the site controller in your meter cupboard and see right away what your charger is doing, why it does not charge and what you can do yourself. No login needed, day and night.
Do you use the MyCharger app, or is there a small box with a QR label in your meter cupboard? Then you are in the right place, even if your charger carries another brand name.
Enter the code and you see, within seconds: is the charger online, what each charging point is doing, why it does not charge if it does not, any fault in plain words with what to do about it, and whether its software is up to date (and if not, why not). It works day and night, without logging in. It is often faster than mailing us, because it shows the same live data our support desk looks at.
Where do I find the code? On the site controller: the small module in your meter cupboard, not the charger itself. There are two ways to get it:
- Read it from the label. The code is printed on the label with the QR code: 10 letters and digits. Type it in exactly as printed; capitals matter.
- Scan the QR code with your phone’s camera app. Tap the link that appears. A page opens with the code at the end of its address, after
id=. Copy that whole address and paste it in the box above; the check picks out the code itself.
Why a charger does not charge
These are the reasons we see most often. The check above tells you which one applies to your charger.
The car is plugged in, but charging does not start.
Most often there is not enough current available to start. The charger shares the capacity of your home connection with everything else in the house; when the heat pump, oven or washing machine is on, there may be too little left to start (at least 6 A, and some older cars need more). Charging starts by itself when there is room again. Other common causes: charging is set to start later (delayed charging or a schedule in the app), “plug and charge” is off so you start charging in the app, or solar charging is waiting for enough sun.
The charger offers power, but the car does not take it.
Then the charger is fine and the car decides not to charge: the battery is full or at the limit set in the car, a charging schedule in the car or in the car maker’s app is active, or the car is asleep. Check the car’s charging settings and try again.
The charger is offline.
The site controller in the meter cupboard has no connection with our server. Charging and load balancing go on, but the app and the check cannot see the charger. Check that it has power and look at its LED. To restart a grey site controller, switch its circuit breaker off for 30 seconds and on again; for a black one on the smart meter, pull its plug out of the P1 port for 3 seconds. If your WiFi changed (new router, name or password), set up WiFi again in the MyCharger app. The FAQ explains the LED colours and the restart for each type.
The charger shows a fault or a red light.
Reset it: unplug the car, switch the charger’s RCD off for 3 seconds and on again, then plug the car back in. The check names the fault. If it keeps coming back, a DC leakage fault usually points to the car or the earthing of the house; the FAQ explains what to check.
The charger charges slowly.
The check shows why: the home connection is busy, a maximum current is set, the car takes less (many cars charge on one phase), or the cable limits it.
My subscription has expired.
Without a subscription the charger still charges and balances the load, but the app, the check and remote support do not work. The check then shows a link to renew.
Still not solved?
Use the chat and type your code: it reads the same data and answers questions. Or mail support@edgetech.eu with a photo of the QR label on the site controller, what the check said and what you have already tried. We answer within one working day. More ways to reach us are on the contact page.